Sign up on the Revelation Software website to have access to the most current content, and to be able to ask questions and get answers from the Revelation community

Processing Gauges (OpenInsight Specific)

At 27 JAN 1999 04:32:40PM BMC wrote:

How do I get a "gas gauge" to display in a situation like this..

statuscode=Set_Status(0)

Call RLIST(SCmd,"5","","","")

If Get_Status(statuscode) Then 

  xmsg=statuscode
  Gosub ErrMsg
  Goto EndOfJob

End

*

Loop 

   Readnext @ID else Eoj=1

Until Eoj do

  • * would like gauge to display **
   Read ....
   End

Repeat

*

Any examples or guidance?

Thanks

At 28 JAN 1999 08:44AM [email protected] - [url=http://www.sprezzatura.com]Sprezzatura, Inc.[/url] wrote:

From the MSG_EQUATES Insert record:

* to display a gauge (percent bar), use the "G" type; sub-types are C (show

* cancel button) and Y (yield on each cycle):

*

* Def="

* Def=Processing Orders…"

* Def=GC"

* Def=OrderCnt

* MsgUp=Msg(@window, Def)

* for Order=1 to OrderCnt

* gosub ProcessOrder

* * update the gauge and check if cancel was pressed

* while Msg(@window, MsgUp, Order, MSGINSTUPDATE$)

* next Order

* Msg(@window, MsgUp) ;* take down the gauge

[email protected]

Sprezzatura, Inc.

www.sprezzatura.com_zz.jpg

At 28 JAN 1999 10:29AM BMC wrote:

Thanks Aaron I will give it a whirl or should I say I'll gauge it.

View this thread on the forum...