guides:programming:programmers_reference_manual:reado

ReadO statement

Use to read a record that you do not intend to modify.

ReadO variable From [table_var Cursor cursorvar], key Then | Else statements

The ReadO statement has the following parameters.

ParameterDescription
variableAssigned the value of the data from the specified column of the row specified by key.
Table_varA table variable that has been previously specified in an Open statement.
cursorvarIf accessing a cursor, cursorvar contains a cursor variable. Cursor variables are initialized with a Select…By statement and must be preceded with the word Cursor.


If the table being accessed has had control features added, cursor access will automatically invoke domain conversion during a ReadO.
KeyThe row referenced by key will be read from the table identified by table_var or the table accessed using the cursor in cursorvar.
ThenThe statements in the Then clause will be executed if a row is read successfully.
ElseThe statement(s) following Else are executed if the row in variable cannot be read. The Status() function indicates the severity of the error, and the system variable @FILE_ERROR contains details about the nature of the error.

ReadO is used to read a row that will not be updated. As a consequence, the read request may be fulfilled from any cache or buffers being maintained by the filing system. ReadO, therefore, can be a faster method of accessing data than by using the Read statement. In a multi-user environment, ReadO does not necessarily read the most current version of a row.

Note: The definition of ReadO (and the use of caches or buffers) is specific to the filing system being used. Many filing systems do not cache data and therefore implement Read and ReadO identically.

/*  This code fragment counts the number of bytes in the CUSTOMERS table.

The result is stored in data_bytes at the end of the loop.  ReadO is used because record locking is unnecessary, since the only purpose of reading each row is to determine its length.

*/

 

Open "CUSTOMERS" To customers_file Then

data_bytes = 0

Select customers_file

Done = 0

Loop

  ReadNext @id Else Done = 1

Until Done do

  ReadO @record From customers_file, @id Then

    data_bytes += len(@record) + len(@id)

  End

Repeat

/*  data_bytes contains the number of data bytes in the table. */

End
  • guides/programming/programmers_reference_manual/reado.txt
  • Last modified: 2024/06/19 20:20
  • by 127.0.0.1