DOS Temporary File Invalid under NT with NPP (Networking Products)
At 14 JUN 2000 07:40:59PM Eduardo Murphy wrote:
We have the following problem, under the following conditions:
-Windows NT Workstations 4.0, with Administrator's rights (Full Control) of reading, writing, and deleting files over the entire C: disk (in which the Arev resides).
-Arev 3.12, with the NPP 1.5 installed, and 5 users.
When we log into Arev, we get the message
"Your DOS Temporary Files are Invalid..."We also get error messages with various commands (LIST,for example), that seem to write/read in temporary files.
When we edit, save, or re-read a DOS file (Using EDIT DOS from TCL), we get a message that says:
"Undefined error read/write/delete"This last error shows up always with the first try from TCL in a session, and then behaviors erratically.
We haven't explicitly configured anything in the Workstation, or in the REVPARAM.
We would preciate any suggestion.
At 15 JUN 2000 02:42PM Eduardo Murphy wrote:
Fortunately, we found the solution to the problem in an article in the Knowledge Base, about increasing the number of File Handlers of Advanced Revelation on NT, and the solution was increasing the number of FILES in CONFIG.NT.