Upgraded from OI v3.7.5 to v4.0.1 - everything went fine - no errors.

But after upgrade, if I choose the

Netware NML Multi-user Driver ver 1.5b

I cannot lauch OI - it give an error

 Attempt to log in too many users

    then

 OpenInsight boot up failed

If I select the

 All Networks Driver

then I can lauch OI, but it will not use the tables in my volumes due

to the REVPARM file in the volumes!

OI v3.7.5 works fine -

Setup on OI v3.7.5

File Server - Novell v4.11 with SP9 installed (P4,1.5GB RAM)

Workstation(s) - Windows 98 SE (Pentium 4, 256MB RAM)

Network Driver - IPX/Netware Multi-user Driver ver. 1.5a

I can still lauch the OI v3.7.5 with no problem, but the OI v4.0.1

will not boot up!

Things I have tried -

1. Contacted REV Tech Support - they suggested to install then NLM

   client side into the OI v4.0.1

2. Backed up the OI v4.0.1 then

   Re-install the NLM (client side) into OI v4.0.1 from orginal 

   diskettes 

  (this made it even worse - so restored the OI v4.0.1 from backup)

3. Contacted REV Tech Support again - they sent me an LHNLM.DLL file

   dated 02/21/02.  I installed this file with same results.

4. Searched Online Discussion for upgrade problems - printed the 

   one from Craig about old LH*.DLL files and deleted those

   remaining files in OI v4.0.1 - still no help.

Notice that the IPX/Netware Multi-user Driver ver. 1.5a is not an

option in the OI v4.0.1 NetDrv selection area!

Any suggestions are greatly appreciated.

See this thread.

Pat

Pat,

If you read my "tried so far" section, I had already printed that

thread and removed the files and tried to lauch again with no

success.

Still same problem -

Leon,

Oops, sorry about that, right you are.

Are you running OpenInsight on a local drive and then trying to access files on a separate mapped networked drive?  If so, I have reproduced this and hopefully will have a fix shortly.

Pat McNerthney

OI32 Grunt Coder

Hi Pat,

No, OpenInsight is installed on the Novell File Server, as was

the OI v3.75 - Data Tables reside on same Novell File Server.

Nothing changed with mapping or accessing location with program or

data, just did the upgrade, and did what I indicated in the 1st part

of this thread. - Like I said - OI v3.75 works fine in same location.

Update on condition of getting into v4.0.1

If I reboot my workstation, I can boot into OI 1 time. But if I get out of OI, I cannot get boot back into OI - Too many users message. -

I reboot my workstation again, and I can get into OI v4.0.1

1 time again, but if I close it and try to get back into without

rebooting workstation - same message - Too many users.

Leon-

I was able to duplicate then fix this with the new driver we sent you via email. I tried to call you at your office; you've already left for the day. I'll talk to you first thing Monday morning.

Thanks-

Mike

View this thread on the forum...