We are running Arev 3.12 on Novell with the NLM. On one of our machines (mine), I have started getting an error message while logging in: "STDIOERR Line 2 Variable has not been assigned a value. Zero used." The machine then locks up.

If I access Arev without using the NLM (not using lhipxtsr) I don't get this message. Of course I can't do that.

The error started happening when our application was moved to a different server. The old one ran Novell 3.12. The new one runs 4.1. I'm running Windows 95 while others in our office are running Windows 98.

Can anyone offer a solution?

Ron Wielage

More info:

The PC is a Dell running an Olicom token ring card running both TCP/IP and IPX/SPX protocols. Advanced IPX tab shows "Primary logical board" unchecked, nothing in "Frame type of primary logical board", "Use all detected frame types" is checked, "Use only the following frame types" unchecked. Bindings is "Novell Netware Client", "IPX retry count" is 20, "Allow IPX access through interrupt 7AH" is checked, "Allow IPX access through interrupt 64H" is checkedk "IPX diagnostics enabled" is checked, "Pre-allocate VGNMA memory" is unchecked, "Enable Source routing over NDIS" is unchecked, "SPX connections" is 15, "SPX verify timeout" is 54, "SPX listen timeout" is 108, "SPX abort timeout" is 540, and "Allow connection watchdogging" is checked.

Ron

Ron

Try defining the frame type and board.

[email protected]

Sprezzatura Group

View this thread on the forum...