Universal Driver and OI Main directory question (Networking Products)
At 05 JUN 2004 02:43:16PM B. Cameron wrote:
I have upgraded a client from LH Service 2.x to the UD 3.0.0.2 this weekend. (OI 16)
The previous configuration I had taken and split up the .exes and .dlls from the OI main directory into ..\runtime and ..\develop
For the UD install I put all the dlls and exes back and the developer oengine. Performed the install, got rid of all the revparams and then created 1 new revparam in the OI main directory.
I then cut/copied the .exes and .dlls back into
..\runtime and ..\develop and left the revparam under the oi main.
We logged in and tested 10 or so WS and I logged in as developer.
All seems fine but I wanted to check and see if anyone has any comments about this setup. Could there be some data corruption that I would not see? Any comments or suggestions appreciated.
BC
At 09 JUN 2004 08:56AM Steve Smith wrote:
Depends on whether you've hard-wired any set-files or attaches, or else stored these as config data inside your app.
At 09 JUN 2004 11:29AM B. Cameron wrote:
Nope, got rid of all those. Thanks for the reply.