Designing a form with a splitter and a tab control (OpenInsight 32-Bit)
At 24 JAN 2008 08:20:56PM Colin Rule wrote:
I want to create a form with a horizotal splitter about 2/3rds down the screen, and below this I want a tab control, and the form set with say 3 pages.
On the first page, I do this, but as soon as you go to page 2 in Form Designer, the tab jumps up, and its a real mess.
Any suggestions please as to how to design a screen like this.
Colin
At 25 JAN 2008 09:07AM Sean FitzSimons wrote:
Colin,
When the form is run, the Tab Control stays on the below the splitter bar, so this seems to be a problem in designing the form.
If you remove the splitter bar the behavior goes away.
I suggest designing the form with the splitter bar in mind but not placing the splitter bar on the form until the last possible moment.
Sean
At 28 JAN 2008 11:29AM DSig wrote:
Colin, dont forget to add to bug tracker
At 30 JAN 2008 08:58PM Colin Rule wrote:
Oh it I had the time
At 30 JAN 2008 09:01PM Colin Rule wrote:
Sean
I will try this, but this means I have to remove it whenever I want to change or add a control on pages 2+.
A nasty bug, I will have to see if I can create the control when the form is run, and hope the controls around it will behave.
Any suggestions on how to do this would be GREEAATTTTTT.
Colin