BRW unable to connect to OI (Banded Report Writer)
At 29 DEC 2011 07:28:58PM Jim Vaughan wrote:
OI 9.3
When I run the new BRW using an run time engine I get an error:
Unable to connect to OpenInsight…terminating…
and the BRW exits and does not run. If I use my dev engine instead it works correctly.
At 30 DEC 2011 09:14AM bshumsky wrote:
OI 9.3
When I run the new BRW using an run time engine I get an error:
Unable to connect to OpenInsight…terminating…
and the BRW exits and does not run. If I use my dev engine instead it works correctly.
Hi, Jim. Just to clarify - the dev engine and the run time engine are on the same PC, right? Are they even running in the same OI (and you're just swapping the engine), or are there 2 OI's set up on this PC?
Did you run the client setup after you installed the 9.3 release (non-beta) version?
Thanks,
- Bryan Shumsky
At 30 DEC 2011 01:37PM Jim Vaughan wrote:
All on the same PC yes just swapping the engine. Only one install. Yes I ran the client setup.
Jim R Vaughan
At 30 DEC 2011 02:50PM Jared Bratu wrote:
I get the same problem in my test environment. All I did was modify my example application in a clean system and add another button to the examples form to launch the BRW by CALL RTI_BRWSUPPORT("LAUNCH").
Having the run time engine produces the error message Jim described. Swapping back to the Dev engine works just fine.