Okay, I'm assuming that when I hear beeping when I'm in a form that something is "wrong" or there's something that I need to look into. Well as I am developing and testing various forms, I have been hearing "beeps". Before I get too far along, does anyone have any suggestions as to what I should be looking at to determine what's causing my forms to beep? The beeps aren't necessarily reproducible, that is, when I move to a control, I may hear a beep. If I move back to it again, I may not. The only think I can say for certain is that I will hear beeping within certain forms.

Thanks. rayc@symmetryinfo.com onmouseover=window.status=imagine … ;return(true)"

Symmetry Info

Ray Chan ~ Symmetry Info

Ray-

When you hear a beep, look at the System Monitor. You should see messages like 'XXX does not exist' or 'XXX is an invalid dictionary word'

Hope it helps-

Mike Ruane

Mike,

When you hear a beep, look at the System Monitor. You should see messages like 'XXX does not exist' or 'XXX is an invalid dictionary word'

Well, I've looked at the system monitor and I don't see any unusual messages. Now I'm running the form under test mode. That shouldn't make a difference should it?

rayc@symmetryinfo.com onmouseover=window.status=imagine … ;return(true)"

Symmetry Info

Ray Chan ~ Symmetry Info

Also-

If the system monitor is open, it will fill up and refresh after it hits the 64k limit, and it beeps when it does that.

View this thread on the Works forum...